BHG Forklift Training

Forklift Training & Certification in Amarillo, Texas

Amarillo's forklifts work in meat processing plants, grocery and fulfillment warehouses along I-40, and manufacturing plants that ship across the Panhandle. BHG Forklift Training comes to your Amarillo facility and trains and evaluates your operators on the trucks they run.

  • OSHA Classes 1–7
  • Training at Your Facility
  • Hands-On Evaluations
  • Certification Records
Request Forklift Training

Forklift Operator Training in Amarillo

The Amarillo Economic Development Corporation describes the city as the largest between Dallas and Denver and between Albuquerque and Oklahoma City. It sits on Interstate 40, connects south to Lubbock on I-27 and has BNSF rail service. AEDC says food manufacturing has been the area's largest export category, drawn from about 14 million acres of surrounding farmland and a large cattle and dairy sector. It names Tyson Foods among the city's established processors and Owens Corning among its larger manufacturers, and it points to Amazon's fulfillment center and last-mile delivery facility as evidence that national distributors are moving in.

For forklift operators, that mix means very different days. In a meat plant, they work on wet, cold floors next to production lines. In a fulfillment center or grocery warehouse, they pull orders from high racking and load trailers on a tight schedule. At a roofing or fiberglass plant, they move heavy, bulky finished product out to open yards, where Panhandle wind decides how much can be carried at once. OSHA requires training that fits each truck and each workplace, so BHG does the training at your site.

BHG Forklift Training operates under BHG Safety Partners LLC, a Disabled Veteran-Owned firm headquartered in Hannibal, Missouri. We travel from Hannibal to Amarillo and train on the trucks your crews already use: classroom instruction first, then hands-on practice, then an evaluation of each operator in your own aisles, docks and yard. Training is available in English or Spanish. After an operator passes, your company signs the certification.

Where Forklifts Work in Amarillo

  • Meat and food processing

    AEDC lists Tyson Foods among Amarillo's major manufacturing employers and says the region is one of the nation's top beef producers, with major processing plants nearby. Processing plants and their cold storage areas have wet and sometimes icy floors, freezer doors, pallet jacks crossing paths with workers on foot, and battery-powered trucks that lose capacity in the cold.

  • I-40 grocery, fulfillment and last-mile warehouses

    AEDC names Affiliated Foods among local food companies and cites Amazon's fulfillment center and last-mile delivery facility in Amarillo. Warehouses like these run reach trucks and order pickers in high racking and pallet jacks at busy docks, and training has to cover rack loading, trailer securing and routes shared with pedestrians.

  • Roofing, fiberglass and steel manufacturing

    AEDC reports that Owens Corning employs 650 people in Amarillo making roofing products, and it highlights local makers of fiberglass tanks and pipe and fabricated structural steel. Wide, tall or awkward loads like bundled shingles, tanks and steel members need attention to capacity plates, load centers and visibility, especially when trucks carry them across outdoor yards.

  • BNSF rail and freight corridors

    AEDC describes Amarillo as a freight corridor city on I-40, one of the country's most heavily traveled east-west freight routes, with BNSF rail access. Transload docks and rail-served warehouses depend on operators who can work boxcar dock plates and bridge plates correctly, chock rail cars and trailers, and plan how to handle loads that shifted in transit.

What Shapes Forklift Safety in Amarillo

  • Texas has no OSHA-approved State Plan, so private employers in Amarillo fall under federal OSHA and 29 CFR 1910.178. The forklift standard excludes farm vehicles, and agriculture on the farm is regulated separately. That exclusion does not reach meat plants, grain and feed warehouses or distribution centers, where the full operator training and evaluation requirement applies.

  • NWS Amarillo reports that on March 14, 2025, the Amarillo airport's weather station measured a record 83 mph wind, and blowing dust cut visibility below a quarter mile. Strong gusts like these can push a raised load off balance and turn a routine yard move into a hazard. Employers should set a wind limit for outdoor lifting and check air filters on engine-powered trucks after dust events.

  • NOAA's 1991-2020 normals for Amarillo show 107.9 nights a year at or below freezing and 17.2 inches of snow, along with 72.4 days at 90 degrees or higher. Winter brings icy dock approaches, frosted forks and slow-starting propane trucks, so a pre-shift inspection matters year-round.

Forklift Classes Amarillo Employers Need Most

All forklift classes
Client Questions

Amarillo Forklift Training Questions

We get a lot of the same great questions from new clients. Here are the answers to the ones we hear most often — if yours isn't listed, don't hesitate to reach out directly.

BHG Forklift Training instructor leading an onsite training session

Onsite Forklift Training Session

Federal OSHA's Lubbock Area Office, at 1205 Texas Avenue, Room 806 in Lubbock. OSHA's county list places both Potter and Randall counties under that office, since there is no area office in Amarillo itself. Texas does not have a State Plan for private employers, so 29 CFR 1910.178 is the forklift rule that applies.
Almost certainly not. 1910.178 excludes farm vehicles, and on-farm agriculture is regulated separately. Once product reaches a processing plant, feed mill, grain warehouse or distribution center, though, the forklifts moving it are covered by the general industry standard. Every operator needs training, practice and a workplace evaluation on the trucks they use.
Cover wet and icy floors, stopping distances on slick concrete, freezer doors and blind corners, battery performance in the cold, and keeping clear of workers on foot near production lines. Operators should also be evaluated on the actual loads they move, such as boxed product and combo bins. BHG runs that evaluation in your own coolers and docks.
OSHA requires an evaluation of each operator's performance at least once every three years. Refresher training is also required after an unsafe operation or accident, after a near miss, after an evaluation shows a problem, or when an operator is assigned a different truck or the workplace changes. We can run those evaluations at your Amarillo site.
About BHG

Your Safety. Our Mission.

BHG Forklift Training trains and evaluates forklift operators at your facility, on your own trucks. Our instructors bring decades of hands-on experience in warehouses, distribution centers, manufacturing plants and construction sites.

Our approach is simple: we listen first. Every facility has its own trucks, layout and traffic patterns. We build each session around your equipment, your aisles and docks, and your shifts — so your operators train for the work they actually do.

From Class 1 electric riders in the warehouse to Class 7 rough terrain forklifts on the job site, we cover every OSHA truck class, from our base in Hannibal, Missouri to employers across 17 states in the Midwest and South, in English or Spanish.

Trusted Since 2014
Disabled Veteran-Owned Small Business

Get in Contact with us Here!

Fill out the form below and we'll be in touch within one business day.

Get a Quote